Features: High bonding strength:

Renabond adhesive which made up of highly formulated polymers gives good bonding strength between the blocks which suits for both load bearing and framed structure constructions.

Higher coverage:

Renabond AAC joint mortar covers up to 70 sqft , considering the thickness of the mortar 2-3 mm. Cost savings: Renabond an ready to use AAC joint mortar, saves money in way of transportation & sieving of sand labour cost.

Less mortar required:

Unless like conventional cement mortar where 10-12 mm thickness of mortar required to lay between the red bricks, Renabond requires only 2-3 mm thickness of mortar.

No wastage:

We going to use the AAC block laying special trowel tool to paste the renabond between two blocks, so no wastage of mortar in this case of application.

No curing:

The self-curing properties of renabond adhesive leaves no curing after application, thus water is saved

Ready to mix:

Renabond the Ready to use adhesive can be used just by adding water at the prescribed ratio.

Cleaning the Renacon AAC block:

Before laying the AAC block, the side layers of the block should be made wet with soft sponge.

Laying the first line:

The first line of AAC block need to be done by conventional method for better result.

From Second layer:

After the laying the first level, from second layer renabond should be applied both horizontally and vertically with special trowel with 2-3 mm thickness.

General note:

After laying AAC block for 4 feet , it is recommended to do sill concrete for every 4 feet to get best bonding, strength and avoid cracks in future